Type Catalog No. Module Gear ratio Material Heat treatment Tooth surface
finish
Precision
JIS B 1704:1978
Secondary
Operations
NOTE 2
Features
hypoid-gear MHP 1~1.5 15~200 SCM415 Carburizing
NOTE 1
Hobbed 3 High speed reduction ratio, high efficiency, high rigidity and compact gear assembly.
Spiral bevel gears MBSG 2~4 2 SCM415 Carburizing
NOTE 1
Ground 1 High strength, abrasion-resistant and compact for high-speed & torque use.
SBSG 2~4 1.5~3 S45C Teeth Induction Hardened Ground 2 Reasonably priced ground gear, yet remachinable except for the gear teeth.
KSP
F type
1.5~5 1.5、2 SCM415 Carburized Ground 0 × Superior performance with regard to high speed, low noise, and low vibration.
KSP
U type
1.5~5 1.5、2 SCM415 Carburizing
NOTE 1
Ground 0 Superior performance with regard to high speed, low noise, and low vibration.
MBSA・MBSB 2~6 1.5~3 SCM415 Carburized Hobbed 4 × Ready to use without performing secondary operations. Strong and abrasion resistant.
SBS 1~5 1.5~4 S45C Teeth Induction Hardened Hobbed 4 Large nos. of teeth and modules are offered in these affordable spiral bevel gears.
Zerol Bevel Gears SBZG 2~3 1.5~2 S45C Teeth Induction Hardened Ground 2
These products are spiral bevel gears, which have a helix angle less than 10 degree. Zerol bevel gears receive forces from the same direction as straight bevel gears receive and has excellent precision properties.
Straight bevel gears SB・SBY 1~8 1.5~4 S45C Hobbed 3 Popular series of straight bevel gears for many uses.
Bevel Gears & Pinion Shafts (SB) 1.5~3 5 S45C Normalizing (pinion only) Hobbed 3 Popular series of straight bevel gears for many uses.
SUB 1.5~3 1.5~3 SUS303 Hobbed 3 Suitable for food machinery due to SUS303’s rust-resistant quality.
PB 1~3 1.5~3 MC901 Hobbed 4 MC nylon products are light and can be used without lubricant.
DB 0.5~1 2 Duracon
(M90-44)
Injection molded 6 Injection molded, mass-produced products, suitable for office machines.
【NOTE 1】 Although these are carburized products, secondary operations can be performed as the bore and the hub portions are masked during the carburization. However, as a precaution, high hardness (HRC40 at maximum) occurs in some cases.
【NOTE 2】 ○Possible    △Partly possible ×Not possible


Copyright (C) 1996 KOHARA GEAR INDUSTRY CO.,LTD.
All Rights Reserved.