KHK Stock Gears 3013

108SpurGearsHelicalGearsInternalGearsRacksCP Racks& PinionsMiterGearsBevelGearsScrewGearsWormGear PairBevelGearboxesOtherProductsSpur Gears with Built-In ClampsModule 0.8SSAY/KCatalog No.ModuleNo. of teethShapeBorePitch dia.Outside dia.Face widthSet ScrewAllowable torque (N·m)AH7CDESizeJBending strengthSurface durabilitySSAY0.8-28/K6m0.828S5622.4246M56.33.550.26SSAY0.8-30/K6 /K830S5682425.66M56.37.33.890.30SSAY0.8-32/K6 /K832S56825.627.26M56. /K835S5682829.66M56.37.34.770.41SSAY0.8-36/K6 /K836S56828.830.46M56.37.34.950.43SSAY0.8-40/K6 /K8 /K1040S568103233.66M56. /K8 /K1045S568103637.66M56. /K8 /K1048S5681038.4406M56. /K8 /K1050S568104041.66M56. /K8 /K1055S568104445.66M56. /K8 /K1056S5681044.846.46M56. /K8 /K1060S568104849.66M56.[Caution on Product Characteristics]① For products with a tapped hole, a set screw is included.② The allowable torques shown in the table are calculated values according to the assumed usage conditions. Please see Page 31 for more details.③ The backlash values shown in the table are the theoretical values for the backlash in the normal direction of a pair of identical gears in mesh.④ The reference slipping torques shown in the table are experimentally obtained by attaching the gears to shafts with g6 tolerance and 0.4a surface finish. ⑤ Do not tighten the clamping screw without inserting a shaft, or the bore will be permanently deformed and will not accept a shaft.*The gear grade listed is the value before clamping. The precision grade of products with a module of less than 0.8 is equivalent to the value shown in the table.SpecificationsPrecision gradeJIS grade N8 (JIS B1702-1: 1998)*JIS grade4 (JIS B1702: 1976) Gear teethStandard full depthPressure angle20°MaterialS45CHeat treatment ―Tooth hardness(less than 194HB)